17 December 2010

Endwave develops enhanced QFN packages to 50GHz

Endwave Corp of San Jose, CA, USA, which designs and manufactures high-frequency RF monolithic microwave integrated-circuit (MMICs) and integrated transmit/receive modules, says that, by re-engineering the widely accepted QFN (quad flat no-leads) surface-mount technology (SMT) package of its MMIC products, it has more than doubled the usable frequency range of the housing, increasing its upper-frequency limit to 50GHz and higher.

A standard QFN package is a micro-lead-frame-type SMT housing designed to provide protection for MMICs and other semiconductors while also simplifying their attachment to printed-circuit boards. Due to their design, QFNs allow solder connections directly to PCB traces, without the complexity of fabricating plated through holes (PTHs) in the circuit board. Standard lower-cost plastic-molded QFN packages operate to about 3GHz, while conventional higher-performance air-cavity QFNs can be used to about 25GHz.

Because of the high operating frequencies of its MMIC and multilithic microsystem (MLMS) passive components, Endwave has re-engineered conventional QFN packages to achieve extended-frequency performance. For example, the lengths of bond wires within the package, used to connect device bond pads to package ports, are minimized wherever possible with the aid of custom laminate sections and a double-reverse bonding technique. This results in reduced parasitic circuit elements and higher-frequency operation of plastic QFN packages, with lower insertion loss and minimal phase distortion through 50GHz.

Endwave characterizes the electrical performance of its enhanced QFN packages by means of calibrated vector network analyzers (VNAs) with millimeter-wave frequency capability. Using specially designed test fixtures to minimize the impact of the test setup on the behavior of the package, the housings are evaluated with and without attached die to optimize package performance for each of Endwave’s MMIC product lines, including its single-function and multi-function MMICs, including frequency up-converters and down-converters, amplifiers, and voltage-controlled oscillators (VCOs).

Tags: Endwave

Visit: www.endwave.com

See Latest IssueRSS Feed